Changing pitch of cast buttplate

[WonkyEye]

Hi All,
I have a silly question, because I'm sure the answer is obvious, just not to me and I don't recall seeing it mentioned in any books or videos I've watched. My cast brass (bronze?) buttplate is set for a pitch of about 1". For me, with a big chest, that digs in at the toe and I need about 6" pitch. If I align the butt portion, it leaves the part at the heel jutting up at an ugly angle. How do I bend it down without hosing up the complex curves? I'm guessing it involves a torch, a vise, maybe a couple wooden blocks and
maybe a mallet? Also don't be alarmed, this is a construction lumber practice stock to help me figure out all my dimensions and to work out some of my mistakes before I get to the fancy maple.

 

[stubshaft]

I would anneal the plate before attempting to bend it. Cast brass is brittle and prone to cracking.

I would also straighten it out more and NOT try to maintain the original shape (angle) of the original buttplate.

 

[SDSmlf]

Anneal and bend/beat that butt plate into submission. Get the angle you want then fit the stock to it. May require a few tweaks of the butt plate along the way.

Very common ‘adjustment’ in my experience. And for what it is worth, I have a few ‘broken’ examples in the spare parts draw. ANNEAL the butt plate BEFORE any aggressive adjustments. Cast brass isn’t always that forgiving.

 

[Tumbledown]

You don't place the butt against the chest. It should go against your arm by your armpit, aiming cross-body. Inlet the wood more and don't risk cracking or breaking the casting.

 

[andy52]

You don't place the butt against the chest. It should go against your arm by your armpit, aiming cross-body. Inlet the wood more and don't risk cracking or breaking the casting.

That type hold is the traditional way of shouldering a crest butt plate, I've never tried to adjust one to fit myself.

 

[ChuckJonesWagon]

I would think you want to bend it where I have the arrows pointed. I would anneal the brass to a cherry red (quench with water....it won't matter if you let it cool or quench it), then move the metal with your choice of hammer, wood pieces against vice jaws, etc.

It's going to be important that the metal is annealed and soft before you do this....or it will likely crack.

 

[James Kibler]

Clamp the top return in a vise and bend away. No need to anneal or fuss around.

 

[Vol423]

I think the angle between the top return and the plate is a little off, but you mostly need to I let the buttplate into the stock.