English Fowler wrist profile

[Onojutta]

How does the profile look on this English Fowler wrist in process? Does it need to slim down toward the rear near the nose of the comb? Thanks

 

[rich pierce]

Looks like there’s a tiny dip in the top line where the carving meets the wrist. One way to fix that is to play with the top profile where the carving is, then renew the carving as needed. Of course there’s always a minuscule drop-off from carving to wrist but the overall curvature should remain the same.

Regarding the taper of the wrist, I often subtly taper it downward toward the toe.

 

[Hatchet-Jack]

The line could be improved. I use a small 1/2" pillar file with a safe edge. I hold it like I am draw filing and work it back and forth between the carving to the comb. It doesn't take much to feather it out. Being careful not to hit the edge of the carving.

 

[Larry (Omaha)]

Looks like there’s a tiny dip in the top line where the carving meets the wrist. One way to fix that is to play with the top profile where the carving is, then renew the carving as needed. Of course there’s always a minuscule drop-off from carving to wrist but the overall curvature should remain the same.

Regarding the taper of the wrist, I often subtly taper it downward toward the toe.

I agree with the dip, but wonder if correction will need some thinning or bending on the tang end. Dunno where that is from the photo. Thinning would be OK if needed as long as the metal is there. Bending, I would worry about the joint between wood and tang opening up.
Larry