Flat face breech brushes

[Capnball]

Started off with 1” dia Navel Brass turned to whatever dia you want then drill thru for tap drill size for a Stainless Steel screw then drill about 3/8 deep for the bristles then tap for thread and part off. Lock tite screw inserted inside of body. Buy a brush with the type of bristles you like and cut to length and epoxy them in.

Slick!

 

[Harry Joe Wolf]

If you have a "Navel Brass" item your stomach might get cold.
I recommend you get some "Naval Brass".

 

[Zonie]

Har. Har. Har.

 

[GregLaRoche]

That brush sounds like a great idea. I think I might try to make one for myself.

 

[Kansas Kid]

I sold a couple at the last Rendezvous to revolver shooters for scrubbing bottom of cylinder chambers.

 

[MrMackc]

I use.45ACP or a.3006 (cut off) brass and tap out the primer hole and epoxy in bristles from acid brushes which I buy in bulk.

Another question, have any of you squirted engine starting fluid in the nipple and used a #11 cap to blow a dry ball or detached patch and jig out of a barrel?