Gizmo for final barrel inletting

[rich pierce]

Sometimes the edges of a barrel inlet need a tiny bit of relieving as we finish the inletting. Just too tight, and we don’t want to have to pry a barrel out of a forestock. It can be challenging to take a tiny bit out from the high spots and keep the sides of the inlet square and clean. Today it occurred to me that a jig for filing the tops of chainsaw bars to even and square them, might work. Bingo. It works very nicely.

 

[PEARL DRUMS]

I like it. And I see its depth is adjustable making it even more handy for the "shoulder" on an octagon channel.

 

[springfield art]

Yet another good idea tip from a muzzleloader! Who'da thunk? This site is full of great tips!

 

[springfield art]

Sometimes the edges of a barrel inlet need a tiny bit of relieving as we finish the inletting. Just too tight, and we don’t want to have to pry a barrel out of a forestock. It can be challenging to take a tiny bit out from the high spots and keep the sides of the inlet square and clean. Today it occurred to me that a jig for filing the tops of chainsaw bars to even and square them, might work. Bingo. It works very nicely. View attachment 372956View attachment 372957View attachment 372958

Great tip! If this was sold specifically as an inlet tool to gun-makers, it would cost 4 times as much!!

 

[rich pierce]

https://www.amazon.com/01-Dressers-...200-49a3-864e-d426b7382f19&pd_rd_i=B08PVT86MW