Make a pistol Trigger Guard from sheet brass

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
That's where I ordered from Amazon. Hope its the correct thing.
Your thickness should be at least 80-thousands. Thicker will work, but don’t go overboard.

I ordered from Amazon…then they shipped it from California (I’m in Pa), then it got lost in the snow for a week, then I cancelled it and ordered from TOTW. Then….4 days later I got the TOTW order…..and the California shipment.

Go figure. I sent the California order back.
 
Your thickness should be at least 80-thousands. Thicker will work, but don’t go overboard.

I ordered from Amazon…then they shipped it from California (I’m in Pa), then it got lost in the snow for a week, then I cancelled it and ordered from TOTW. Then….4 days later I got the TOTW order…..and the California shipment.

Go figure. I sent the California order back.
I didn't know what size I needed. Figured 1/16" would be about right. 1" wide x 12" long.
 
1/16” is .0625”. That’s a little skinnier than I prefer, but you could be OK with that.
Looked good on the 1/16 mark on my tape measure. I have a flintlock pistol with one and it looks less than the 1/16.
Hopefully it will work.
I guess if I disclosed what I'm wanting it for. Its for a band around a double barrel shotgun.
 
Back
Top