Make a pistol Trigger Guard from sheet brass

[ChuckJonesWagon]

That's where I ordered from Amazon. Hope its the correct thing.

Your thickness should be at least 80-thousands. Thicker will work, but don’t go overboard.

I ordered from Amazon…then they shipped it from California (I’m in Pa), then it got lost in the snow for a week, then I cancelled it and ordered from TOTW. Then….4 days later I got the TOTW order…..and the California shipment.

Go figure. I sent the California order back.

 

[2 shots]

nice work and personalized also.

 

[Jappo]

Your thickness should be at least 80-thousands. Thicker will work, but don’t go overboard.

I ordered from Amazon…then they shipped it from California (I’m in Pa), then it got lost in the snow for a week, then I cancelled it and ordered from TOTW. Then….4 days later I got the TOTW order…..and the California shipment.

Go figure. I sent the California order back.

I didn't know what size I needed. Figured 1/16" would be about right. 1" wide x 12" long.

 

[ChuckJonesWagon]

1/16” is .0625”. That’s a little skinnier than I prefer, but you could be OK with that.

 

[Jappo]

1/16” is .0625”. That’s a little skinnier than I prefer, but you could be OK with that.

Looked good on the 1/16 mark on my tape measure. I have a flintlock pistol with one and it looks less than the 1/16.
Hopefully it will work.
I guess if I disclosed what I'm wanting it for. Its for a band around a double barrel shotgun.

 

[ChuckJonesWagon]

Looked good on the 1/16 mark on my tape measure. I have a flintlock pistol with one and it looks less than the 1/16.
Hopefully it will work.
I guess if I disclosed what I'm wanting it for. Its for a band around a double barrel shotgun.

Then that should work just fine.