-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
MVTC Ketland Pistol trigger job
- Thread starter alrany187
- Start date
Help Support Muzzleloading Forum:
You will have to dismantle your lock and then, very carefully and lightly, stone the hammer and sear. That should at least get you started in the right direction. It may be that you also have a long travel on the sear and that could be built up so the sear doesn't go so deep into the full cock notch. Others may have more specific info as to your particular gun.
- Joined
- Mar 3, 2005
- Messages
- 76
- Reaction score
- 166
On mine the spring that presses on the trigger bar was pretty stiff, so I carefully thinned the lower part of the v spring. The trigger pull is quite nice now.
