Recommended revolver parts to upgrade or have as spares?

[Widows Son]

Hello, I hope everyone is doing well.

I’ve got a Uberti 1858 Navy .36 that was made in 1978. It’s in excellent condition but nothing lasts forever and I’d like to have on hand some replacement parts; and perhaps some higher quality parts if possible.

I’m visiting family in the US soon and whilst I’m there I should take advantage of the lower prices and greater parts availability.

I’ve already got slix-shot nipples on my list, but what else?

 

[RiverRat]

Today I replaced a worn hand assembly for my Uberti 1860 army. I purchased it in 2005. I keep some extra trigger/bolt flat springs on hand. A spare bolt assembly wouldn’t be a bad idea.

 

[wiscoaster]

Slixshot nipples would be my #1, and I see they're already on your list.

 

[ppg1949]

I have Pietta in the same revolver. I bought all the screws, trigger & bolt spring and cylinder hand off ebay in two purchases. The hand required minor fitting. But you probably have ebay down under. Welcome to the USA and good luck.

 

[Widows Son]

Thanks very much for the advice.

Does anyone know if the hand/trigger spring/bolt/screws etc. are the same as a .44 Army?

And a recommended vendor? I was thinking about Dixie Gun Works

 

[AlexB]

https://www.midwayusa.com/product/1973292517?pid=883599
One of these for if the loading lever catch pops off and a set of screws.

 

[nick_1]

taylors is the best for replacement parts. better if you talk to someone on the phone though. I have accidently ordered Uberti parts for my Pietta and they are not interchangeable. last time I called and the person on the phone was very helpfull and I got the right parts.

 

[bpalbee]

Hello, I hope everyone is doing well.

I’ve got a Uberti 1858 Navy .36 that was made in 1978. It’s in excellent condition but nothing lasts forever and I’d like to have on hand some replacement parts; and perhaps some higher quality parts if possible.

I’m visiting family in the US soon and whilst I’m there I should take advantage of the lower prices and greater parts availability.

I’ve already got slix-shot nipples on my list, but what else?

I have a Uberti 1860 made in 1979 and I replaced the bolt recently. The springs seemed a little higher quality during that era but spare bolt/trigger springs and spare hands as mentioned. Might be harder to find but a replacement hammer is probably next on the wear list, the little cam the bolt rides on wears if not properly hardened, properly lubed, or bolt leg properly tapered

 

[M. De Land]

Hello, I hope everyone is doing well.

I’ve got a Uberti 1858 Navy .36 that was made in 1978. It’s in excellent condition but nothing lasts forever and I’d like to have on hand some replacement parts; and perhaps some higher quality parts if possible.

I’m visiting family in the US soon and whilst I’m there I should take advantage of the lower prices and greater parts availability.

I’ve already got slix-shot nipples on my list, but what else?

About the only thing that breaks on them is the trigger spring and even that is remote when you go to wire or stainless steel flat spring stock. Might want to get a set of slix shot nipples.

 

[Jappo]

Deercreek Products is a good source for parts. I found parts for the Armi San Marco there. And of course ebay.
A hand, bolt and the bolt/trigger spring would be a good idea. Maybe a hammer and spring also. Sometimes the hammer cam can give problems.