James Stella
40 Cal.
- Joined
- Sep 4, 2012
- Messages
- 368
- Reaction score
- 51
I stripped the finish off my Lyman GPR so I could refinish it. See below picture on progress.
http://www.flickr.com/photos/90803536@N08/8241347345
What I would like to do is take the ivory from the elk I shot and inlet it into the bottom of the stock. See pic #2. I have never done anything like this before and am looking for some tool suggestions. What would you use to do an inlet job like this?
http://www.flickr.com/photos/90803536@N08/8241346995/in/photostream
Thank you.
http://www.flickr.com/photos/90803536@N08/8241347345
What I would like to do is take the ivory from the elk I shot and inlet it into the bottom of the stock. See pic #2. I have never done anything like this before and am looking for some tool suggestions. What would you use to do an inlet job like this?
http://www.flickr.com/photos/90803536@N08/8241346995/in/photostream
Thank you.
Last edited by a moderator: