Touch Hole Vent

[dcriner]

If you decide to leave the liner in place, and then sometime in the future you absolutely must be remove, you can always get it out with an easyout. The liner may need to be drilled out a bit for the easyout to fit, and of course the liner will have to be replaced.

Heating the liner will make it expand, thus making it even tighter. Better to heat the barrel steel adjacent to the liner - that will enlarge the female hole. But I haven't had much luck using this approach with other stuck threads.

 

[Stubert]

The pedersoli liner needs to be opened up, and usually coned fron the inside. Order a new one, modify it and take the old one out with an e-z out if you have to. You will enjoy much better ignition.

 

[tg]

Mosr knowledgeble buki,lders use a liner that is filed fluch so they cannot be removed it is not a required part of cleaning thegun nor is taking off the barrel and one does not need any special tools to avoid getting then outside of the gun wet, just use a bit of caution/common sense ansd it will work fine with both in place, removing these just adds to the time it takes and posible unneeded wear on parts, good luck with your new found mistress and enjoy the journey