Under lug strip?

[4570tc]

Ok this is another "I used buy question."

I used to buy a strip casting of 3 brass under lugs for mounting the barrel to the stock? I cannot find them anymore??
Does anyone know where they sell them at now a days?

TIA

 

[Pete G]

Ok this is another "I used buy question."

I used to buy a strip casting of 3 brass under lugs for mounting the barrel to the stock? I cannot find them anymore??
Does anyone know where they sell them at now a days?

TIA

Make ‘em.

 

[4570tc]

Make ‘em.

I was hoping not to have to fire up the mill for such a small job! may I'll make a strip of 10" long?
That will last a long time!

 

[wiscoaster]

I was hoping not to have to fire up the mill for such a small job! may I'll make a strip of 10" long?
That will last a long time!

You could make a few cents selling the extras here in the classifieds section.

 

[PEARL DRUMS]

I'm making mine from .030 steel banding from work. Made the RR tubes last weekend from the same stuff. I scuffed the paint off first. The solder grabbed right on. I know you asked about brass. But, thought I would give you something else to consider.

 

[sdilts]

Knob Mountain Muzzleloading has them. https://knobmountainmuzzleloading.com/Parts.html

 

[ZUG]

The ones that I remember were poorly sand castings and had to be cleaned up a lot. You are better off either using your mill or make them out of sheet brass. I also have a milling machine, but I rather make them out of sheet brass and solder/braze then together for added strength.

 

[4570tc]

The ones that I remember were poorly sand castings and had to be cleaned up a lot. You are better off either using your mill or make them out of sheet brass. I also have a milling machine, but I rather make them out of sheet brass and solder/braze then together for added strength.

Do you cut dovetails for them, or jus solder them to the barrel?