What gravers are typically used for English Fowler engraving?

[Texcl2]

I was going to pick up a graver or two with my next tow order. What gravers do yall use for borders on lock plates and butt plates and maybe a little scroll like you’d see on a low tier English trade fowler? Don’t worry I’m using practice plates not a gun .

 

[dave_person]

Hi,
Don't buy any gravers from TOW. Go here (www.airgraver.com) and click on manual engraving. Read all about Lindsay sharpening templates and buy the stones and templates. For an 18th century English gun you need a small square, a small flat, and a round bottomed graver. If you use the search function on this site you will find many posts about engraving. If you don't learn to sharpen correctly, you will go nowhere and just ruin your guns. Lindsay's templates are the fool proof way to go.

dave

 

[Texcl2]

Awesome, thanks Dave.

 

[sussexmuzllodr]

As always sound advise from Dave.
Dave do you commission out any engraving work?

 

[LRB]

Awesome, thanks Dave.

Also, look up Sam Alfano. His work is some of the best and he is a good teacher for hammer and chisel work and push engraving.

 

[LRB]

Hi,
Don't buy any gravers from TOW. Go here (www.airgraver.com) and click on manual engraving. Read all about Lindsay sharpening templates and buy the stones and templates. For an 18th century English gun you need a small square, a small flat, and a round bottomed graver. If you use the search function on this site you will find many posts about engraving. If you don't learn to sharpen correctly, you will go nowhere and just ruin your guns. Lindsay's templates are the fool proof way to go.

dave

Hi Dave. Just curious, what do you do with a round graver. I have never used one but then I was much an amateur at the skill.

 

[Cruzatte]

I book marked your response, Dave. Thanks ever.

 

[dave_person]

Hi Wick,
Here are two examples I did copied from original English guns.

The deep cuts that create shading and depth in the volutes and leaves are done with the round bottomed cutter. English engravers often combined a bunch of converging lines with round bottomed cuts to bring depth and shading detail to their work. I also use them when sculpting metal such as this side plate.

dave

 

[dave_person]

As always sound advise from Dave.
Dave do you commission out any engraving work?

Hi,
Unfortunately no. I just don't have the time to add that to my work load. I do occasionally engrave regimental markings on muskets for reenactors but just a few each year.

dave

 

[Texcl2]

Amazing work Dave!