Read my patch...
- Thread starter YampaValleyMountainMan
- Start date
Help Support Muzzleloading Forum:
Smooth bore or rifled?
- Joined
- Mar 13, 2020
- Messages
- 7,491
- Reaction score
- 21,006
- Location
- On the Border in Idaho looking at BC
slight rifling cut, but looks good to me.
YampaValleyMountainMan
32 Cal
Another one...
Attachments
My input is, your patches do not look all that bad, however they could be better. IMO, they show signs of definite blow by. They also show signs of sharp edges in the bore. I suggest you try a .018 patch. My .54 GPR likes a .018 patch, Mink Oil and 90 grains of 3F with a .530 RB. It is to my belief that what I mentioned above will tighten up your groups overall. Your ML will break in after a while, thus the sharp edges will become a non-factor over time.
Good luck.
Last edited:
- Joined
- Jul 8, 2019
- Messages
- 3,169
- Reaction score
- 5,697
I have never seen a patch with so little damage and that light?
Lapping with a piece of green scotchbrite wrapped on an undersized bore brush gets rid of the sharp edges pretty fast.
longcruise
70 Cal.
Not good! Should be no cutting of the patch material where it rides the bore. You can get acceptable accuracy with a patch like that but it can definitely do better. Polish the bore, Polish and shape the muzzle/crown and try the same patching and maybe thicker if it will load.
YampaValleyMountainMan
32 Cal
The barrel has been shot for almost a decade by it's previous owner.
Could it still be sharp?
Could it still be sharp?
Depends on how many times it was shot.
First I would try .018 patches. Your ML most likely will like them and your groups should prove it. Maybe that’s all need be done.
If there’s still some cutting, I would lightly lap the barrel/polish the barrel.
FWIW, you might already know this but not all ticking is created equal. Do yourself a huge favor and order some high quality ticking.
Good luck.
Last edited:
Indeed, could be an issue at the crown as well. Good point, Cruiser.
I hope to cone the muzzle on my GPR soon to facilitate loading and no more short starter. That will take care of any crown issue if one is damaged on any ML. I do not have that issue on mine but coning the muzzle is a win-win.
ronaldrothb49
45 Cal.
- Joined
- Oct 31, 2021
- Messages
- 834
- Reaction score
- 1,425
My first question would be what does your target look like? Do you have a group or are your shots all over the place? In my experience where the balls are going is more important than what a patch looks like. I have had new rifles in the past which just shredded the patches but the shots were in a nice group. Over the next 50 shots those groups closed up to one hole as the barrel got broke in. It's more fun to shoot it to break the barrel in than all that other stuff.
Southernboy
32 Cal
What is the group like?
SB
SB
Hatchet-Jack
54 Cal.
Fair to middlin
GM barrels have wide grooves. A thicker patch or .535 ball will help. Also the muzzle crown may need the sharp edges rounded over. Just break the sharp crown with a needle file and polish it with your thumb and wet-dry sandpaper.
I shoot a 54 Colerain barrel I use a 535 round ball .005 patch 80 grains of Goex fff spit patch shoots 1” groups at 50 yards.
Similar threads
