.32 Kentucky rifle and water jug test

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

David LaPell

32 Cal
Joined
May 27, 2024
Messages
40
Reaction score
122
Location
Adirondack Mountains of New York
I did a test was with the Pedersoli Kentucky Rifle using 1 gallon water jugs. four of them lined up, again, same load as before, 25 grains of FFFG Schutzen, and a .010" patch. The .311" roundballs I used were cast from .570" Hornady balls I recycled and melted down. The jugs were shot from about 7 yards away, the .311" ball went through the first three jugs, entered the fourth and bounced off the backside of the fourth creating a slight dimple. The roundball suffered no deformation at all.

The four water jugs right as the .311" ball hits the first jug.

roundballwatertest1.jpg



roundballwatertest2.jpg


The dimple in the back of the fourth jug.

roundballwatertest6.jpg




The .311" ball after the water jug test.


roundballwatertest3.JPG


roundballwatertest4.JPG


roundballwatertest5.JPG
 
Saw your video on YouTube, interesting results. Any idea on the velocity with this load ? I would have thought some deformation. However, with my 50 cal pistol with 25 grains of 3F, the ball don't deform either. I estimate velocity at around 700-750 fps out of my pistol.
 
For my 32 Pedersoli Kentucky, I found that a .315" ball and a .010" patch worked best. With a hand cast .311" ball I didnt get the accuracy AND the load of 25g of FFF Swiss seemed 'lite'. Then I read that Pedersoli recommends the .315 ball and .010 patch. Tried it and the groups are now one holers and the shots sound more like a bang and not a pfffft. The patches also show full engagement now.
 

Latest posts

Back
Top