• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Kibler SMR shooting help.

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Joel2937

32 Cal
Joined
Sep 27, 2024
Messages
4
Reaction score
0
Location
Nebraska
Hello Everyone,
I'm new to flintlocks. I built a Kibler .45cal SMR kit. I have shot the rifle ( which is a blast!!), I would like some advise on what ball, patch and powder charge combination would be the most accurate? Thank you for the help. ( I'm currently using .440 balls, .010 patch, and powder 40 grains to 60).
 
Are you using FF or FFF powder? Your rifle may like 3F. A lot of the 45 cal folks use that and have stated it's more accurate. I'm working up a load for a new 45 cal I have. So far I've just used 2F, but next range outing I will try 3F
 
i use 70 grains of FFF a .445 ball with a .015 patch for targets. 90 grains for hunting
 

Attachments

  • IMG_0331.jpeg
    IMG_0331.jpeg
    1 MB
Shooting my Kibler .45 cal SMR I use a 0.445 ball with a 0.010 patch and 60 gr of 3F powder.

OP, your ball and your load seems to be to be a bit undersized. Tighter fit is better, though load depends on group results. If you don't have to use some force to start your ball then either your ball is undersized or your patch is too thin.
 

Latest posts

Back
Top