• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Search results

Shop deals on ebay
L & R
Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    lead flux

    If you are using scrap lead I would clean and flux(with any of the above mentioned make sure sawdust is dry) before I put it in my casting pot, but once clean I stur with the hickory hammer handle I use to open the spur plate.
  2. M

    Missouri Muzzle loader season

    This is what happens when you give a them open ended funding by a specific tax. There is no real way for state reps to influnce there funding.
  3. M

    casting question ?

    bullshop spurplate lube is the best I have found. 2cycle oil works well also a drop on a Q tip applied to a warm mold is all that is required. As for lead pipe use caution when smelting, my only visit from the tinsel fairy was from pipe. I rest my aluminum molds on my elect pot while it is...
  4. M

    KIK Blackpowder Questions

    I ordered Goex and KIK FFFg from Powderinc last week. I am shooting them in a 36" 50 cal, I cannot tell much difference in point of impact vel (measured with a beta chrony at 30') or fouling.
  5. M

    carrying a flintlock in the woods

    While shooting my new TVM Poorboy kit tonight I noticed I had developed a flintch so I wanted to dry fire a few times. I had already loaded the rifle but did not prime, first pull flinch not to bad second pull BOOM. My point being I would not let an empty pan lull me into thinking a rifle is...
  6. M

    Fluxing Lead

    I think a hickory stick works better than soft wood. Sawdust will also work I use it for cleaning dirty lead then use a stick or wax to flux before casting.
Back
Top