FlinterNick
69 Cal.
- Joined
- Nov 1, 2018
- Messages
- 3,956
- Reaction score
- 2,998
Looking to see how folks counter bore screw holes on their lock kits.
On this M1717 lock, the pan screw needs to be flush or slightly below the surface.
I was able to counterbore it with an end mill bit, however I was not very pleased with it. The pan is attached and works fine, however I do feel there is a much cleaner approach to counter boring (not counter sinking).
Does anyone have any easier method ?
On this M1717 lock, the pan screw needs to be flush or slightly below the surface.
I was able to counterbore it with an end mill bit, however I was not very pleased with it. The pan is attached and works fine, however I do feel there is a much cleaner approach to counter boring (not counter sinking).
Does anyone have any easier method ?
Attachments
Last edited:
