Hickock 45 Dry Balls It

[TNGhost]

One way to skin a cat.

 

[kh54]

I think of the dozen or so dry balls I’ve had I have only pulled one. All the others I’ve cleared exactly like that. Always works for me.

I have read somewhere, I think on this forum, that the bolster screw is there only to plug a hole that was necessary in the manufacturing process and was never intended as a cleanout access. Can anyone clarify?

 

[Grenadier1758]

I'm one of those that identify the "cleanout" screw as a manufacturing plug. Many original rifles do not have that threaded plug in the drum or as part of the breech plug. T/C has called the treaded plug a "cleanout" screw and after replacing so many ruined screws redesigned their breech to eliminate it.

Now, of course when the threaded plug with a slot exists, it can be used with the purpose of augmenting the cleaning flush with a percussion nipple removed. One does get more cleaning solvent through the approximately 1/4" nipple hole than the #8 threaded "cleanout" hole and it can be useful for adding powder when dry balled. On general those threaded plugs are too soft and often the slotted head is ruined by over torquing or the threads are turned in too far and block the nipple or cover nipple's flash hole. The fouling will freeze the plug in place. Best to believe it doesn't exist and leave it alone.

 

[Racer X]

This has always been a fear of mine. Thankfully I haven't done it yet!

I always enjoy videos from Hickok45, thanks for sharing.

 

[Indy Durtdigger]

I'm one of those that identify the "cleanout" screw as a manufacturing plug. Many original rifles do not have that threaded plug in the drum or as part of the breech plug. T/C has called the treaded plug a "cleanout" screw and after replacing so many ruined screws redesigned their breech to eliminate it.

I think the only older TC I have that doesn't have that screw messed up us one I found NIB on consignment some years ago. What's bad, even after moving that machining port to the other side and removing the head of the plug during finishing you still run across one every now and then that someone has messed with it. Been a couple threads on here in the last year or so about needing a replacement plug on the later ones because people can't leave stuff alone.

 

[Tom A Hawk]

Saw that yesterday. Its amazing how much oomph comes from a few grains of priming powder. Now...where can I get a three band Springfield....

 

[GrizzLeeBear]

I have removed my own and others tight patched roundballs with powder in the vent/nipple and with ball puller. In this case I think a ball puller would actually be the easiest. The minie ball is undersized and the only thing holding it in place is probably the fouling. I would think it would come out real easy with a puller.

 

[Siringo]

I think of the dozen or so dry balls I’ve had I have only pulled one. All the others I’ve cleared exactly like that. Always works for me.

I have read somewhere, I think on this forum, that the bolster screw is there only to plug a hole that was necessary in the manufacturing process and was never intended as a cleanout access. Can anyone clarify?

I needed to take my out on my orginal all the time to clean out the fire channel.

 

[Frontstuffer070]

STOP using tapered ground screwdrivers on your guns!! I cringed watching him use that screwdriver on that original. If he had the correct tool for the job (SQUARE GROUND FLAT TIP) He wouldn't have been slipping and fumbling with that screw. There is NO tapered slot in ANY flat head screw. Just my .02

 

[Dude]

It sure made me cringe seeing the force applied to the wrong screwdriver (for the job), slipping off and skidding across the gun.

Also, there was enough powder in there, that it wasn't necessary for those extra few grains to remain preventing the screw seating completely.