Removing the barrel on a hooked breech rifle for cleaning, yes or no??

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Conversely, Those of mine without a patent breech get shot less due to the increased cleaning effort, perceived or otherwise.
 
Last edited:
Hooked breech comes out of the stock for cleaning.

I built myself a Tennessee flintlock with an over the comb tang. The barrel Never comes out of the stock.

My other full stock pinned barrel guns generally get cleaned in the stock by pumping water thru it with a piece of hose on the nipple or my homemade clamp on hose for the flintlocks....but plugging the nipple or vent and running patched works as well.

Half stocks are too easily taken down for cleaning so they are barrel off.

Just depends on the gun being cleaned....YMMV
 
Last edited:
Mine come out of the stock to get cleaned in the bathtub or a bucket. I was taught that way and it seems to work just fine.
 
only if I clean the rifle for longtime storrage,
normaly I clean it direct with a few patches after shooting then a good oil and that´s it.
 
I have one of those cleaning nipples with tubing attached that I screw in, stick the tube in a jug of hot water and Dawn, and pump away with the range rod sucking the water in and out. leaving the barrel in the stock makes that process easier, ergonomically, and it doesnt leak. I like doing this rather than stick the whole barrel end in the soapy water. I then take the barrel off and run patches thru it until its dry and clean. I figure, I'm taking the nipple off anyway, may as well use the cleaning nipple. Watching the water pass thru the clear tube change from black to grey to mostly clear lets me know when its clean.
 
I remove the barrel from my hooked breech guns for cleaning. I'm meticulous when it comes to cleaning guns of any kind but especially with muzzleloaders.

Barrel off, nipple (percussion guns) removed, hot water with Dawn pumped through the barrel until patches come out clean, boiling water poured through barrel to rinse (allows barrel to dry quickly), dry patches until moisture is gone then wipe bore using patches with Barricade. When the barrel cools I hit it with another Barricade patch.
 
Last edited:
Back
Top