• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Repro 1620 Matchlock Musket

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
That is a good question. I would say that coming up with a stock profile that fit me well so that I could be sure I could shoot it well. I have a very long 14 5/8" length of pull. I did lengthen that dimension a bit from the original. Otherwise, it was a pretty smooth build. Making the screws got a bit boring....
 
It looks like you based your matchlock on the same original that I did for mine. You did a much nicer job on yours than I did though.
 
Excellent!
Does the serpantine jaws adjust, or is that just wedge shaped so all diamters of match can just be slid down until it is tight?
Again, excellent!
 
Good question. They do adjust. When you tighten the thumb screw, it pushes the jaws of the serpentine open. Place the match in and turn it out. This tightens the leaves of the serpentine against the cord.
 
Back
Top