• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Woodsrunners

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
In one of recent vids he says it takes 1 hr & 45 min to CNC a Woodsrunner stock. So, could be a while 1
 
Vid I saw shows that butt plate being a pretty complex milling operation. It's all curves.

I ordered one fully knowing I won't see it until next year. I just finished a Lancaster build. Maybe I'll actually do some shooting for a while.
 
It will get here when it gets here. That’s what I keep telling myself. Over and over and over and over and over again!🥹
Deep breaths there, fella...deeeep breaths. You're in good company.

The Woodsrunner Anticipation Club (WAC) is forming. Support meetings Tuesday nights. :)
 
Two weeks ago I called to place a second order, I was told then that they had a lot of barrels, stocks, locks and packing boxes. The only hold up is the butt plates. You’d think a few would be out there.
I don't think Jim will put them out until every process is perfected.
 

Latest posts

Back
Top