-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
How to cut grease notches in a ‘58 Remington cylinder pin?
- Thread starter Widows Son
- Start date
Help Support Muzzleloading Forum:
I did it and it works well.
Blackie has a dandy moving picture film on the You Tube regarding this.
Blackie has a dandy moving picture film on the You Tube regarding this.
Wonder how the fouling works back to the grooves without a pathway . . . magic I reckon .
Mike
blfuller
32 Cal
You could chuck it up in a drill or drill press and cut the grooves with a triangular file.
Yes, but hard to control. The flat spot on the pin is going to give you a bump. Best to do it by hand. Only a very slight ring is needed, if at all. I have rems I've done and others I have not and don't really notice a difference but I usually only shoot 3, maybe 4 cylinders. No binding but the pin will get hard to pull.
I use white lithium grease on Remington's and have no problem with cylinder stickiness, galling, hanging up-whatever term ya want to apply. Have shot it up to 3-4 hours at a time, grease in front of the cylinder turns brown is all. I slather as much as possible on it from the get-go. Use the white lithium on Colt arbors also, only thing that happens is brown grease a bit in from cylinder face. Have used the white lithium since early 90's.
