- Joined
- May 6, 2013
- Messages
- 4,340
- Reaction score
- 10,025
After I got the initial side plate ....uhm ...." hole " in there then I inlet black the side plate put it back.in there tight , pop it back out and then remove the black from the bottom but also the sides ( you can't see it ) but the sides will have tiny bit of black on there and remove that too for the S.P. to go down there , be careful esp. where the higher wood is fragile , youll knock that piece out and either have to glue piece back in , if you can find it , leave it looking crappy or have to fill it in ....more work . Drill the third hole and put that screw in ... Going over stock now , final shaping troublesome parts and final sanding soon ... Hopefully finish coat soon