Unknown Flintlock pistol

[Jappo]

Got this to hang on my wall. But after inspection I noticed the lock looked real. Well curiosity got me. Put a flint in it and it sparked good. So I added a little 2f to the pan and it went poof. I asked myself. Why would someone put a working lock on a prop gun?
Now the barrel had a plug about half way down.
Why not. Got a wooden dowel and a hammer. Tapped on it started moving. Few good strikes and it popped out.
All I have is a DeWalt hand drill. But what the heck. Did the drilling. First the barrel then the plug. Tapped in in (its tight) to where the holes matched. Put the barrel back on. Added about 10gr loose 2f and some in the frizzen. It went poof whoosh.
I disassembled the entire gun. The lock has Spain on it. Going to disassemble it and give it a good cleaning.
I do have a question. Should I buy a tap and die and thread it. Or find a welder to weld it for me. I probably won't be shooting any balls out of it. Probably just a noise maker or some bird shot.

 

[Sam squanch]

Do not shoot that barrel.

 

[Jappo]

Sellers pictures.

 

[hawkeye2]

I wouldn't trust that barrel but if you are determined to work on it do it right. You can blow the breech out with a blank and the next person who gets it may try to fire it with a real load and ball.

 

[springfield art]

Do not shoot that barrel.

Agree.

 

[Relic shooter]

Sellers pictures.

For display only !
Often the metal parts are cast from soft zinc/pot metal.

 

[tenngun]

Isn’t that a CVA’tower pistol’ from the 1970? I had one and it shot well
Just goofy looking compared to historical guns
You can get fuse from Dixie and set it off from a distance,

 

[Jappo]

Isn’t that a CVA’tower pistol’ from the 1970? I had one and it shot well
Just goofy looking compared to historical guns
You can get fuse from Dixie and set it off from a distance,

Those are my plans after I get the correct breech plug. When I drilled the flash hole, it wasn't to easy, but it was doable. The barrel is by no means just a pipe. Its actually harder than a revolver barrel. Not brittle either. I haven't measured the bore yet. Its set aside right now. Im working on another project.

 

[Jappo]

For display only !
Often the metal parts are cast from soft zinc/pot metal.

Yes sir they look like that. They are steel. Frizzen sparks real good. It ignites 2f powder without any problem. I already disassembled the lock and polished all the parts. The only problem I had was the release sear. I fixed that. So no issues with the lock.

 

[2 shots]

you cant thread it as the plug o.d. is the same as the barrel i.d.

 

[Jappo]

you cant thread it as the plug o.d. is the same as the barrel i.d.

I have a breech plug coming. The barrel od is a bit smaller than 3/8"

 

[wiscoaster]

Looks like a fun project and not too much work to get it looking real purty anyhoo.