What Muzzleloading Stuff Did You Do Today?

[David Austin]

Still sanding the browning off the Cabela's barrel. When I bought the TC renegade I also bought the sellers supplies. Looked it over. I should take a picture. Powder horns...with 2f and 4f, cleaning jags, dryball pullers, lead pot...with lead, casting tongs for calibers I don't have. caps...11's, 204'd , flints...stuff. cleaning solvents, patches, cleaning rods, nipple wrenches, nipples to fit, range box...came with the rifle.

Took delivery of ?? caliber Jukar two pieve percussion rifle NOT CVA.

 

[Kansas Jake]

I epoxied a front sight to 1861 Springfield to sight it in before I solder it permanently.

 

[Norman Brooks]

Turned plug for horn shown.

 

[ArmorerRoy]

I got a new axe.

 

[TDM]

Did a fair amount of shooting today with my .36 SMR. It was not pretty, but you got to show the bad with the good. I had the rifle pretty well dialed in already but I wanted to tweak it for Squirrel hunting. My shooting was off, I’d swear my vision gets worse every year . Was shooting from the bench at 25 & 35 yards. Using .350 cast RBs, .022 patches, and a 1 to 4 ratio Dawn & water lube. I had previously settled on 35 gr of Swiss 3F, but I went back to 30 gr and then up to 40 gr. Seemed like the 40 gr load was printing well so I made a couple of sight adjustments and tried shooting at the squirrel targets. I just could not see them clearly as the results show. But I’ll try again tomorrow. Was using Goex 4F for prime, zero issues with the rifle besides retightening the jaw screw a couple of times. Also had zero problems with fouling. I did swab the bore after about 15 shots but it really wasn’t necessary. The squirrels are relatively safe for now.