Hi guys...Bit of a 'noob' question here...
I am making a 3D model of a percussion revolver ~ I am currently making the cylinder...
What I would like to know is - I presume (daft question I know) that there is a small hole that goes through the middle of the nipple straight into the chamber?
Here's a picture of my cylinder - red marking the hole from the nipple to the chamber ~ does this seem accurate?
Again, apologies for the VERY stupid question. But I haven't found a diagram for 'how a percussion revolver works' to show this process.
Regards, Beaty
I am making a 3D model of a percussion revolver ~ I am currently making the cylinder...
What I would like to know is - I presume (daft question I know) that there is a small hole that goes through the middle of the nipple straight into the chamber?
Here's a picture of my cylinder - red marking the hole from the nipple to the chamber ~ does this seem accurate?
Again, apologies for the VERY stupid question. But I haven't found a diagram for 'how a percussion revolver works' to show this process.
Regards, Beaty